MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 MANUAL
MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 CODE
MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 TV

MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 TV

When the third digit has been entered, the TV button will go out. As each of the digits are entered, the TV button will briefly flash off and on again.

MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 CODE

Now enter the 3-digit brand code according to the make of the TV that is being controlled. After approximately 2 seconds, the TV button will light. Simultaneously press and hold the TV and OK buttons on the remote. Find the TV manufacturer in the TV brand code tables in this manual. Determine the manufacturer of your TV set. TV Control Setup: Brand Search Method: 1. If necessary, press the or (8) button to select another sequential number to save your favourite.4 Luminet SM And Standard Television Equipment Amino Remote - Luminet SM Video Service Only 1ĥ Programming Your Remote: In order for the remote to transmit the correct signals to control the TV, the remote must first be programmed with the 3-digit code corresponding to the make and model of TV in use. Press the source device selection button (2) of the device for which you want to add one or more favourites.

It is also possible to program favourites on the AUX button, but this will have to be configured first for TV or STB mode. programming Favourites This function supports the source device buttons TV and STB only. As soon as the TV set powers back on, the proper device code has been found. If these device codes do not work, you can use the button (8) to go back to the device code where the scan was stopped. Universal Remote Control URC 1001 If you have pressed the PAUSE button (12) too late, you can use the button (8) to return step by step to the previous device codes to check them again. Make sure that the TV set has been powered on and that the remote control points towards the TV set. Proceed as follows to search for the device code automatically (this example refers to programming a TV set). Press the EXIT button (23) multiple times until the remote control has returned to standard mode.

To cancel the following programming at any time, press EXIT (23) to return without saving any changes. If your device is a VCR or a CD or DVD player, please also insert a tape or CD/DVD. This may take a very long time and should be used only if the above methods do not succeed. If the device fails to respond as desired, try the next device code from the list. After a few seconds, the display will return to the device code entry mode. Only for the device type AUX, a fifth digit must be entered to set the device code. If you mistyped the code, you have the chance to enter it again at this time.

Universal Remote Control URC 1001 After you have entered the information, the first digit will blink again. Enter the four digits of the device code that you have found on the list. Search for the first available code by using the device type and manufacturer (see the list starting from page 97). Proceed as follows to enter the device codes directly (this example refers to programming a TV set). Universal Remote Control URC 1001 If the most important device functions work correctly, press the OK button (22) to save the setting. if the device fails to respond as desired, press the button (8) to recall the next available device code. The device is not for use in environments with a high temperature or humidity (e. Position the device on a stable, even surface and do not place any objects on the device.

MANUAL MANDO UNIVERSAL SILVERCREST URC 1001 MANUAL

If you sell the device or pass it on, it is essential you hand over this manual also. Before you use this device for the first time, please read the following notes in this manual and heed all warnings, even if you are familiar with handling electronic devices.

Manual mando universal silvercrest urc 1001